![]() |
Lethe Open-Source Library version 1.2.0
Developer Guide
|
#include <grid_impinging_jet_mixer.h>
Public Member Functions | |
Derived axial coordinates (construction datum). | |
| double | z_chamber_top () const |
| double | z_cone_bottom () const |
| double | z_outlet_bottom () const |
| double | z_dome_center () const |
Public Attributes | |
| double | R_chamber = 0.05 |
| double | r_inlet = 0.02 |
| double | r_outlet = 0.025 |
| double | H_chamber = 0.16 |
| double | L_cone = 0.06 |
| double | L_outlet = 0.05 |
| double | L_inlet = 0.08 |
| double | z_inlet = 0.08 |
Geometry dimensions of the impinging-jet mixer (SI units, metres).
This is the single container for the mixer's geometric dimensions; the defaults below are used when the grid-argument string is empty, and are overridden by the constructor otherwise. The member functions expose the axial coordinates derived from these dimensions in the construction datum (floor of the mixing chamber at z = 0, with the cone and outlet below it at negative z), in which the vessel is built before make_grid() re-datums the mesh so the common inlet axis lands on z = 0.
Definition at line 26 of file grid_impinging_jet_mixer.h.
|
inline |
Definition at line 40 of file grid_impinging_jet_mixer.h.
References H_chamber.
|
inline |
Definition at line 45 of file grid_impinging_jet_mixer.h.
References L_cone.
|
inline |
Definition at line 55 of file grid_impinging_jet_mixer.h.
References H_chamber.
|
inline |
Definition at line 50 of file grid_impinging_jet_mixer.h.
| double MixerGeometry::H_chamber = 0.16 |
chamber height (axial extent)
Definition at line 31 of file grid_impinging_jet_mixer.h.
| double MixerGeometry::L_cone = 0.06 |
axial length of the conical reduction
Definition at line 32 of file grid_impinging_jet_mixer.h.
| double MixerGeometry::L_inlet = 0.08 |
length of each inlet pipe
Definition at line 34 of file grid_impinging_jet_mixer.h.
| double MixerGeometry::L_outlet = 0.05 |
length of the straight outlet pipe
Definition at line 33 of file grid_impinging_jet_mixer.h.
| double MixerGeometry::R_chamber = 0.05 |
mixing-chamber radius
Definition at line 28 of file grid_impinging_jet_mixer.h.
| double MixerGeometry::r_inlet = 0.02 |
inlet-pipe radius
Definition at line 29 of file grid_impinging_jet_mixer.h.
| double MixerGeometry::r_outlet = 0.025 |
outlet-pipe radius
Definition at line 30 of file grid_impinging_jet_mixer.h.
| double MixerGeometry::z_inlet = 0.08 |
inlet-axis height above the chamber floor
Definition at line 35 of file grid_impinging_jet_mixer.h.